Versions Compared

Old Version 8

changes.mady.by.user Justin McCamish

Saved on

compared with

New Version Current

changes.mady.by.user Justin McCamish

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Note

Workbench Workbench’s log file already captures a high volume of information by default so to minimise over-consumption of storage by log files, use extended logging only for as long as necessary to log relevant events .

...

You can add a line to your MettleCI config.yml. This file is typically located at /dm/mci/config.yml

Status
colourBlue
titleUNIX
or C:\dm\mci\config.yml
Status
colourYellow
titleWindows
.

To enable verbose logging, logging…

  1. add the following lines (#3 and #4) within the logging: section in your config.yml file:

    Code Block
    logging:
  ...<snip>...
  loggers:
    com.datamigrators.mettle.process.CommandRunner: DEBUG

...

  1. 
  ...<snip>...

  2. Restart your Workbench service for extended logging to begin.

To disable extended logging simply remove the lines above from your config.yml file and restart your Workbench service again.

Temporary Method

You can use the following command to send a REST call to the Workbench to increase the logging level for the current session without changing your configuration config.yml:

Code Block
curl -X POST -d "logger=com.datamigrators.mettle.process.CommandRunner&level=DEBUG" http://your-engine.your-domain.com:8081/tasks/log-level

This increases the Workbench logging level until the Workbench service is next restarted, at which point the log reverts the settings defined in config.yaml.