Page Comparison

The MettleCI Command Line Interface has a debugging mode which is enabled by inserting entries in a the config.properties configuration file :In in the root directory of your CLI installation (e.g., /opt/dm/mci/cli

Enable debugging by updating the file to contain include the following entrieslines:

# Setting the log level for a specific logger takes the format:
#     logger.[LOG_NAME]=[LOG_LEVEL]

logger.com.datamigrators.mettle.process.CommandRunner=DEBUG
logger.com.datamigrators.mettle.dsadmin.commands.DSParamsMergeCommand=DEBUG

These entries will cause any mettleci command to create a file log/stdout.log file in the current directory from which the CLI command was invoked. This will typically be under your CLI install installation directory (in the sub-directory file log/stdout.log. In the event of a support request you case of manually executed mettleci commands) or in a different directory when invoked by pipeline agents running CLI commands under the direction of a build pipeline. You may be asked to download provide this file and forwarded it to when raising a MettleCI support for analysisrequest.

Available Debug Loggers

...